The RELA-EOL lets you wire a standard non-polarized releasing solenoid onto a supervised, polarized GSA-REL release circuit, so the panel can confirm wiring integrity on suppression system runs instead of leaving that circuit unsupervised.
Built for the commercial fire installer
It mounts in a standard North American 1-gang box (2.5 in. deep) or a 4-inch square box with a 1-gang cover, so there's no special enclosure to source, and the metal faceplate holds up in mechanical rooms and suppression system risers where a plastic cover would take abuse. Terminals accept up to 12 AWG wire for a clean pull.
Key features
- Converts a non-polarized solenoid into a supervised, polarized release circuit
- Metal faceplate for durability in mechanical and suppression equipment rooms
- Mounts to standard 1-gang or 4-inch square boxes — no proprietary enclosure
- Terminals rated to 12 AWG for straightforward field wiring
Compatibility
Designed for use with Kidde GSA-REL releasing modules on clean-agent, CO2, and other suppression release circuits.
Brand:
Kidde Commercial
Form factor:
Polarized end-of-line relay, metal faceplate
Function:
Converts non-polarized solenoid to supervised polarized release circuit
Mounting:
1-gang 2.5" deep box or 4" square box w/ 1-gang cover
Wire rating:
Up to 12 AWG
Compatibility:
Kidde GSA-REL releasing module circuits
What does the RELA-EOL do?
It lets a standard non-polarized releasing solenoid connect to a supervised, polarized GSA-REL release circuit so the panel can monitor that wiring run for faults.
What enclosure does it mount in?
A standard North American 1-gang electrical box (2.5 in. deep minimum) or a 4-inch square box with a 1-gang cover.
What releasing modules is this compatible with?
Kidde GSA-REL releasing modules used on suppression system release circuits.
Spec Sheet
