SECO-LARM USA INC

Enforcer Single-Gang Red LED Strobe with Synchronized 85 dB Buzzer, IP66

SKU SECO-SH-304M-SB/R

  • Red LED strobe and buzzer on one single-gang plate, flashing and beeping in step
  • 10 to 26 VDC at 80 mA, reverse-polarity protected, for 12 or 24 VDC systems
  • 85 dB at 1 ft, adjustable by hand with the baffle wheel on the lens
  • IP66 with epoxy-sealed electronics for wet and dusty locations
  • Fast shipping from four branches
  • 30-day returns on unopened products

Product highlights

  • Power10-26 VDC, 80 mA at 12 VDC
  • Weather ratingIP66, epoxy-sealed
  • MountSingle-gang
  • Output85 dB buzzer, 180° red LED

The SH-304M-SB/R puts a red LED strobe and a buzzer on one single-gang plate, flashing and beeping in step. It gives a door, gate or equipment alarm a visual and audible signal from a single device and a single pair of wires.

Built for the installer

It runs on anything from 10 to 26 VDC, so it takes power straight from a 12 or 24 VDC panel or access control output at 80 mA. Reverse-polarity protection means a swapped pair at trim-out does not cost you the device, and quick-connect spade terminals with the supplied leads keep the termination quick.

Volume adjusts without tools: turn the baffle wheel on top of the lens to open or close the sound ports. The electronics are epoxy sealed and the unit is rated IP66, so it suits wet and dusty locations as well as interior walls.

Key features

  • Strobe and buzzer synchronized at 50 flashes and beeps per minute
  • 85 dB at 1 ft, adjustable with the baffle wheel, no tools needed
  • 180-degree red LED coverage so the alert reads from across the room
  • 10 to 26 VDC with reverse-polarity protection, on 12 or 24 VDC systems
  • IP66, epoxy-sealed electronics for wet and dusty locations

What is in the box

The strobe/buzzer, two wire leads, two faceplate screws and the manual.

Specifications

SKUSECO-SH-304M-SB/R
BrandSECO-LARM USA INC
Form factorSingle-gang strobe/buzzer
Power input10 to 26 VDC
Power consumption80 mA max at 12 VDC
Light1 red LED, 180 degree coverage
Sound output85 dB at 1 ft (30 cm), adjustable
Flash and beep rate50 per minute, synchronized
Weather ratingIP66, epoxy-sealed electronics
Operating humidityUp to 85%, non-condensing
Connector typeQuick-connect spade terminals, 2 wire leads included
ProtectionReverse polarity
MountingSingle-gang, 2 faceplate screws included

Documents and resources

FAQs

What voltage does the SH-304M-SB/R need?
Anything from 10 to 26 VDC, so it runs on 12 or 24 VDC panel and access control outputs. It draws up to 80 mA at 12 VDC and is reverse-polarity protected.
How do I turn the volume down?
Rotate the baffle wheel on top of the LED lens to open or close the baffles. No tools or settings needed. Maximum output is 85 dB at 1 ft.
Can it be installed outdoors?
It is rated IP66 with epoxy-sealed electronics, which covers dust and powerful water jets.
Do the strobe and buzzer run together?
Yes. The red LED flash is synchronized with the beep, at 50 flashes and beeps per minute.