Mounts an ADC-V723 over a single-gang outlet box so the wiring sits inside the box instead of behind the camera. The rubber gasket seals the joint, which is what keeps water out of a box on an exterior wall.
Built for the installer
Using an existing box is often the fastest legitimate way to mount an exterior camera: the penetration already exists, the wiring route is established, and the box takes the mechanical load. The adapter is what makes that a sealed installation rather than a camera screwed over a hole.
It replaces the standard box cover, with the mounting plate, gasket and six screws supplied.
Key features
- Uses an existing single-gang box, so the penetration and wiring route already exist
- Rubber gasket seal keeping water out of the box on an exterior wall
- Wiring contained inside the box rather than behind the camera
- Plate, gasket and six screws included
System requirements
For the Alarm.com ADC-V723 outdoor Wi-Fi camera, mounting to a standard single-gang outlet box. The ADC-OB102 is the dual-gang equivalent.
Brand:
Alarm.com
Compatibility:
Alarm.com ADC-V723 outdoor Wi-Fi camera
Form factor:
Single-gang outlet box adapter
Box size:
Single-gang
Sealing:
Rubber gasket
Pack contents:
Mounting plate adapter, rubber gasket, 6 mounting screws
Dual-gang equivalent:
ADC-OB102
What does this adapter do?
It replaces the standard outlet box cover so an ADC-V723 camera mounts over a single-gang box, with the wiring contained inside the box and a rubber gasket sealing the joint.
Is there a dual-gang version?
Yes, the ADC-OB102. Match the adapter to the box already in the wall.
What is included?
The mounting plate adapter, a rubber gasket and six mounting screws.
