• SS&Si
  • Video Surveillance
  • Alarm.com | 4W Monocrystalline Solar Panel for Battery Cameras, IP65 with Wall Mount | ADC-VACC-SP4W
4W Monocrystalline Solar Panel for Battery Cameras, IP65 with Wall Mount
Alarm.com

4W Monocrystalline Solar Panel for Battery Cameras, IP65 with Wall Mount

SKU ADC-VACC-SP4W

New to SS&Si? Apply for a dealer account
Share
  • Fast shipping from four branches
  • 30-day returns on unopened products
Questions? Call us 866-364-0030The SS&Si dealer team

The accessory that turns a battery camera into one nobody has to go back to. A 4W monocrystalline panel keeps an Alarm.com battery camera topped up continuously, so the recharge visit that would otherwise land every few months stops appearing on the schedule.

Built for the installer

On a portfolio of remote cameras the maintenance visit is the real cost, not the hardware. Removing it changes what is viable to deploy at gates, yards, outbuildings and construction sites. The panel charges intelligently with adaptive temperature protection, so it backs off rather than charging the battery outside its safe range.

It mounts on its own wall bracket with 360 degrees of rotation and 180 degrees of tilt, so the panel can face the sun even when the camera faces something else entirely. The 9.85 ft cord with integrated cable management covers the gap between a shaded camera position and a sunlit mounting point. IP65 rated.

Key features

  • Removes the recharge visit, which is the real cost on a remote camera
  • 360 degree rotation and 180 degree tilt so the panel faces the sun independently of the camera
  • 9.85 ft (3 m) cord with cable management, bridging a shaded camera to a sunlit mount
  • Adaptive temperature protection so charging backs off outside the battery's safe range
  • IP65 rated with wall mount included

System requirements

For Alarm.com battery cameras with a USB-C charging connector, confirmed compatible with the ADC-V731B. Charging operates between 32F and 113F (0C to 45C). Requires a mounting position with meaningful sun exposure.

Specifications

SKUADC-VACC-SP4W
BrandAlarm.com
Form factorSolar panel accessory with wall mount
CompatibilityAlarm.com battery cameras (confirmed: ADC-V731B)
ChargingIntelligent charging with adaptive temperature protection
Weather ratingIP65
Cord length9.85 ft (3 m) with integrated cable management
MountingWall mount included
Cell typeMonocrystalline silicon
Power output4W
ConnectorUSB-C
Positioning360° rotation, 180° tilt
Charging temperature32°F to 113°F (0°C to 45°C)
Operating humidity20% to 100% RH, non-condensing

Documents and resources

FAQs

Which cameras does the ADC-VACC-SP4W work with?
Alarm.com battery-powered cameras. Confirmed compatible with the ADC-V731B Battery Spotlight Camera. Check the camera's spec sheet before pairing with other models.
How much sunlight does the panel need?
A few hours of direct sun per day is enough to offset normal duty cycles on a typical battery camera. Heavy motion-event traffic or full shade locations may still need periodic battery service.
Will the solar panel overcharge or damage the battery?
No. Intelligent charging caps the battery at a safe state of charge, and adaptive-temperature charging suspends charging when the battery is too cold or too hot to safely accept current.
Can the panel be installed outdoors permanently?
Yes. The panel is IP65-rated, the same weather rating as the ADC-V731B, so it is built for permanent outdoor mounting in rain, snow, and heat.
Is the wall mount included?
Yes. A wall mount ships in the box along with the 9.85 ft cord. No additional bracket purchase required for a standard wall install.
All Video Surveillance