The JascoPro Under-Eave Light Power Supply is the second brick installers reach for when a JascoPro Wi-Fi Under-Eave run is longer than what the kit supply can drive. 92W of output, weatherproof housing, and a white cord to match the strand. Mount it under the eave at the far end of the run and feed the next segment.
Built for extended eave runs
The included supply in the white kit (SKU 84429) covers one full 82.5ft. strand run cleanly. Once the job crosses 99 ft or 108 pucks total, a second power source is required. This SKU is what you drop in to pick up the next segment without re-running the low-voltage feed all the way back to the first outlet.
Housing is UV-resistant and rated for permanent outdoor installation. Clips and screws ship in the box, so a standard eave or fascia mount does not need any additional hardware. Cord is white to blend with the 84429 white light strand, the 84430 white add-on strand, and 84431 white extension cords.
Key benefits
- 92W of output to drive a second strand or extension run past the single-supply maximum
- Weatherproof, UV-resistant housing rated for permanent outdoor mounting
- Clips and screws included for direct eave or fascia install with no extra bracket
- Carries power and app control from the JascoPro app through to the strand
- Color-matched white cord to keep the run visually clean end to end
System requirements
Compatible with the JascoPro Wi-Fi Under-Eave Lights white cord kit (SKU 84429), the 84430 white add-on strand, and 84431 white extension cords. For a fresh install, start with the white kit (SKU 84429) and add this SKU when the run extends past the kit's 99 ft / 108 puck maximum. A black cord version of the same power supply is available as SKU 84428.
