The Kidde GSA-CR is a control relay module that gives installers a clean way to silence Genesis Series sounder bases from the FACP. It mounts on the SLC (Signaling Line Circuit) and provides a selectable N.O. or N.C. dry contact rated at 2 amps (24 VDC), letting you tie sounder base silencing into the panel's existing relay programming without running separate NAC wiring.
Built for the fire alarm installer
The GSA-CR is part of Kidde's Intelligent initiating device family and works with any Kidde Intelligent FACP. It addresses on the SLC loop alongside the Genesis Series sounder bases it controls - GSA-S (standard), GSA-SD (standard with drift compensation), and GSA-CSM (ceiling-mount). One module per SLC loop handles silencing for all sounder bases on that circuit.
Key capabilities
- Field-selectable N.O. or N.C. contact adapts to your panel's relay logic without swapping hardware
- 2-amp dry contact at 24 VDC handles the sounder base load on a full SLC loop
- Standard mount form factor installs on the same SLC wiring as the sounder bases it controls
- Works with all Genesis Series sounder bases including GSA-S, GSA-SD, and GSA-CSM models
- UL and ULC listed for commercial fire alarm installations in the US and Canada
System requirements
Requires a Kidde Intelligent FACP with SLC loop capacity. The GSA-CR addresses on the SLC and is programmed through the panel's standard point configuration. No additional power supply or NAC circuit required for the module itself.
What does the GSA-CR do?
Which sounder bases does the GSA-CR work with?
Does the GSA-CR require a separate power supply?
Can I select between N.O. and N.C. operation in the field?
What FACP does this require?
Spec Sheet
