Alarm.com | Aero 12-Output Control Expansion Module for X1100 Door Controller | ADC-AC-X300

Twelve relays on one board, for the jobs where the access control system has to drive more than doors. Elevator floor relays, gate operators, lighting contactors, HVAC interlocks and annunciators all come off the X300 under the same schedules and permissions that run the openings.

Built for the commercial installer

Getting twelve outputs from one module rather than six two-relay boards saves enclosure space, RS-485 addresses and wiring time. Each output is a Form-C contact rated 2 A at 30 VDC, so you have both normally open and normally closed available per point without adding a relay module behind it.

Two programmable inputs come along for local interlock or feedback, plus dedicated tamper, AC fail and battery fail inputs so a remote enclosure supervises itself. UL 294 and UL 1076 recognized, for use with the X1100 controller only.

Key features

• 12 Form-C relay outputs on one board, which saves space, addresses and labour against stacking smaller modules
• Both NO and NC available per output, so no add-on relay is needed to invert a contact
• Drives elevator floors, gates, lighting and interlocks on the same schedules that control the doors
• Two programmable inputs for local feedback or interlock conditions
• UL 294 and UL 1076 recognized for access control and proprietary burglar alarm applications

System requirements

For use with the Alarm.com X1100 Door Controller only. Requires 12 to 24 VDC at 500 mA max and a shielded 2-wire RS-485 run to the controller. Low-voltage Class 2 circuits only.