The Genesis LED EG4 replacement cover gives you a quick field swap for any installed EG4 wall-mount horn/strobe - red housing with FIRE marking to meet standard fire alarm labeling requirements. Snap the old cover off, snap this one on. No rewiring, no disturbing the NAC circuit or device programming behind it.
Built for the commercial fire installer
This is the cover only - the front face plate with integrated horn grille and strobe lens opening. It fits all Genesis LED EG4 Series wall-mount horn/strobe notification appliances. Use it to replace a damaged or discolored cover, change the marking from unmarked to FIRE, or swap from white to red to match the installation requirements. The cover is part of the UL-listed Genesis LED EG4 assembly (UL S928, ULC S5389).
Key details
- Drop-in fit: compatible with all Genesis LED EG4 wall-mount horn/strobe appliances
- Red with FIRE marking: meets standard fire alarm notification labeling requirements per NFPA 72
- Field-swappable: remove and replace the cover without pulling the device off the wall or disconnecting wiring
- Low-profile design: maintains the Genesis EG4's slim wall protrusion
- UL/ULC listed component: listed as part of the Genesis LED EG4 notification appliance assembly
Brand:
Kidde Commercial
Form factor:
Wall-mount horn/strobe replacement cover (face plate only)
Color:
Red
Marking:
FIRE
Compatibility:
Genesis LED EG4 Series wall-mount horn/strobe notification appliances
Compliance:
UL S928, ULC S5389 (listed as part of the Genesis LED EG4 assembly)
What Genesis EG4 models does this cover fit?
Fits all Genesis LED EG4 Series wall-mount horn/strobe notification appliances. If you need to match an existing installed device, check the model number on the device label behind the cover.
Is this just the cover, or does it include electronics?
Cover only. This is the front face plate with the integrated horn grille and strobe lens opening. No electronics, wiring plate, or mounting hardware included.
Do I need to remove the device from the wall to swap the cover?
No. The cover snaps off and on over the installed device. No disconnection from the NAC circuit is required.
Can I use this to change my cover marking from unmarked to FIRE?
Yes. The covers are interchangeable across the Genesis LED EG4 wall-mount family. Swap covers to change between FIRE, ALERT, or unmarked to match the installation requirements.
Spec Sheet
