The EG4AVRN-CVR is a snap-on replacement cover for Kidde Genesis LED EG4 Series wall mount horn-strobe notification appliances. Red housing with no "FIRE" marking - swap covers in the field to change marking or color without rewiring or removing the device from the backbox.
Built for field serviceability
Genesis LED EG4 covers remove with a flathead screwdriver and snap back into place. Need to go from "FIRE" marked to unmarked on an installed, wired appliance? Pull the old cover, snap this one on. No NAC circuit interruption, no wire pulls, no backbox work. The cover preserves full access to the under-cover field-configuration switches for strobe candela output and horn dB settings.
Key details
- Snap-on design: swap with a flathead screwdriver, no special tools
- Red housing, no marking: clean appearance for applications where "FIRE" text is not required or desired
- Fits Genesis LED EG4 horn-strobe appliances: wall mount AV models including EG4AV-R24 variants
- Preserves field access: candela select and horn dB switches remain accessible after cover install
- No rewiring required: cover swap does not disturb the NAC circuit wiring on the GP10 room-side wiring plate
Compatibility
This cover fits Genesis LED EG4 Series wall mount horn-strobe notification appliances only. It does not fit Genesis LED EG1 compact, EGC ceiling mount, or legacy Xenon-based Genesis wall models. The GP10 room-side wiring plate and base electronics are not included - this is the cover only.
Does this cover fit Genesis EG1 or EGC ceiling models?
Can I swap from a FIRE-marked cover to this unmarked cover in the field?
Does this include the wiring plate or electronics?
Will the strobe candela and horn output settings carry over after a cover swap?
What is the difference between the -CVR SKUs?
Spec Sheet
