The Kidde SD-RJ10 is a 10-foot RJ45 wiring harness that connects SuperDuct duct smoke detectors to their remote controllers. Eight-conductor CMP-rated cable with watertight rubber glands at each connector - run it through plenum spaces without extra conduit or re-rating concerns.
Built for the commercial fire installer
SuperDuct systems split the detector head from the controller, and the SD-RJ series harnesses make that connection clean. The RJ45 plugs snap in without stripping or terminating individual conductors, cutting install time on each duct detector location. Rubber glands seal each connector against dust and moisture in HVAC environments.
Key features
- CMP-rated cable: approved for plenum air-handling spaces without additional conduit
- RJ45 snap-in connectors: no wire stripping, no screw terminals - plug and go
- Watertight rubber glands: seal each connector against dust and moisture in duct environments
- 8-conductor cable: carries all signals between the detector head and the remote controller
- 100 ft max run: detector-to-controller wiring distance per Kidde specifications
Compatibility
Connects any SuperDuct RJ45-model detector (SD-SJ series) to any SuperDuct RJ45-model controller (SD-CJ, SD-4WJ). Not compatible with terminal-block SuperDuct models (SD-CT, SD-ST). Also available in 5 ft (SD-RJ5) and 15 ft (SD-RJ15) lengths.
What SuperDuct models does this harness connect?
What is the maximum cable run from detector to controller?
Is this cable rated for plenum spaces?
Can I use a standard Ethernet cable instead?
Spec Sheet
