The Kidde K-276B-1110 is a single action, non-coded fire alarm pull station built with rugged LEXAN 940 polycarbonate for commercial fire alarm systems. Pull the handle to break the glass rod and latch the alarm - no second motion required. Resets with the included 276-K1 key or a compatible tool.
Built for the commercial installer
The 276B Series mounts semi-flush on any standard North American 4-inch square box with single gang plaster cover (minimum depth 2-1/4 inches) or surface-mounts with the optional 276B-RSB back box. Screw terminals simplify field wiring - no splicing or wire leads to deal with. UL Listed under S2318, compatible with any conventional (non-coded) fire alarm control panel that accepts normally open contact initiating devices.
Key features
- Single action activation: one pull breaks the glass rod and latches the alarm handle in position
- Rugged LEXAN 940 housing: red polycarbonate with white raised lettering, visible and durable in high-traffic areas
- Key or tool reset: 276-K1 reset key included - restore toggle switch, replace glass rod, and reclose
- Flexible mounting: semi-flush on standard 4" square box or surface with 276B-RSB back box
- Screw terminal connections: fast, reliable field wiring without splicing
- Single pole, open circuit contacts: rated 3.0A at 30 Vac / 1.0A at 28 Vdc resistive
System requirements
Requires a conventional (non-coded) fire alarm control panel with normally open initiating device circuit. Mounts on standard 4-inch square electrical box with single gang plaster cover for semi-flush installation, or use the 276B-RSB surface back box for surface mounting.
How do you reset the K-276B-1110 after activation?
What mounting box does this pull station require?
Is this pull station compatible with addressable fire alarm panels?
What are the contact ratings?
Where can I get replacement glass rods?
Spec Sheet
