Kidde | Genesis LED G4SE Wall Mount Strobe Expander, White with ALERT Marking, Red Lens | G4SEWA-R

The Genesis LED G4SE Strobe Expander adds visual notification to any Genesis speaker, horn, or chime without replacing the appliance. Mount it behind the existing device on a standard 4-inch square box, wire it into the NAC circuit, and the job is done - no separate strobe run, no extra box, no re-pulling wire.

Built for the commercial fire and mass notification installer

The G4SE uses LED technology for longer service life and lower current draw than incandescent strobes. This model ships in a white housing with red lens and ALERT marking, suited for mass notification applications. Field-selectable candela output via onboard DIP switches lets you set the right intensity for the space without swapping hardware. Synchronizable with Kidde CC Series signal modules, booster and auxiliary power supplies, and intelligent and conventional fire alarm control panels.

Key features

• Pairs with any Genesis notification appliance: speakers, horns, and chimes become speaker-strobes, horn-strobes, or chime-strobes
• LED strobe technology for extended life and reduced current draw (28 mA DC typical)
• Field-selectable candela output via onboard DIP switches - adjust intensity on site without hardware changes
• ALERT marking for mass notification applications (FIRE marking models available separately)
• Standard 4-inch square box mounting - flush mount, indoor wall applications, no special hardware
• Synchronizable across the full Kidde ecosystem - CC Series modules, booster/auxiliary supplies, intelligent and conventional panels

System requirements

Requires a North-American 4-inch square electrical box at least 1-1/2 inches deep. Operates on 16-33 VDC or 16-33 VFWR from the fire alarm control panel NAC circuit. Wire with 12-18 AWG conductors. Maximum 20 ohms wire resistance between any two synchronized devices.